https://www.amceaglesnest.com/guide/index.php?action=history&feed=atom&title=Wiper_Motor_R%26RWiper Motor R&R - Revision history2026-06-19T10:37:30ZRevision history for this page on the wikiMediaWiki 1.24.0https://www.amceaglesnest.com/guide/index.php?title=Wiper_Motor_R%26R&diff=1672&oldid=prevIowaEagle at 22:42, 29 November 20052005-11-29T22:42:23Z<p></p>
<p><b>New page</b></p><div>This will need to be done to facilitate R&R'ing the valve cover; or to replace the motor itself.<br />
<br />
'''Removal'''<br />
<br />
1. Discnonnect wiring harness at motor.<br />
<br />
2. Remove screws attaching motor mounting plate to firewall.<br />
<br />
3. Pull motor and linkage out far enough to expose drive link-to-crank retaining clip.<br />
<br />
4. Raise lock tab of clip up with flat bladed screwdriver and slide clip off of stud.<br />
<br />
5. Remove wiper motor.<br />
<br />
<br />
'''Installation'''<br />
<br />
1. Position wiper motor assembly and insert crank stud back into drive-link hole.<br />
<br />
2. Press clip unto stud and slide into place making sure it locks into place, see figure below.<br />
<br />
[[Image:wiperclip.jpg]]<br />
<br />
3. Position assembly into opening and reinstall mounting screws. Torque to 25 inch pounds.<br />
<br />
4. Reconnect wiring harness.<br />
<br />
5. Check for proper operation.</div>IowaEagle